33.060 - Radiocommunications

REN/ERM-TGMAR-535

The present document specifies technical characteristics and methods of measurements for radio transmitters and
receivers used in the Euroloop communications system. The system is used in railway systems.
The present document applies to the following equipment:
1) The On-Board Equipment (OBE) transmitting the tele-powering to wake-up the Trackside Equipment and
receiving the Euroloop signal. The OBE comprises a receiver fitted with a dedicated antenna.
2) The Trackside Equipment receiving t...view more

REN/ERM-EMC-355

This document shall be considered as a complementary standard to EN 16803-2 that is intended to assessment of the performances of a GBPT placed in real-life or simulated road environments. This document is instead specifically targeting security attacks such as interferences, jamming, meaconing or spoofing. This document cannot be applied independently from EN 16803-2 that describes in details the general methodology of the assessment procedure.
This document provides normative information nece...view more

EN 16803-1 addresses the final stage of the performance management approach, i.e. the assessment of the whole Road ITS system performance equipped with a given Positioning System, using the Sensitivity analysis method.
EN 16803-1 addresses the identification and the definition the positioning performance features and metrics required for Positioning System assessment.
This document gives definitions of the various items to be considered when specifying an Operational scenario and provides a me...view more

This standard specifies the requirements for LTE filters that cover the 700 MHz band in addition to the 800 MHz band. These filters are to be used in individual and MATV antenna installations for reception of DTT signals when the 700 MHz band will be used by telecommunication services (LTE) in addition to the 800 MHz band.

Like the other ENs of the whole series, this EN deals with the use of GNSS-based positioning terminals (GBPT) in road Intelligent Transport Systems (ITS). GNSS-based positioning means that the system providing position data, more precisely Position, Velocity and Time (PVT) data, comprises at least a GNSS receiver and, potentially, for performance improvement, other additional sensor data or sources of information that can be hybridized with GNSS data.
This new EN proposes testing procedures, ba...view more

The present document specifies technical characteristics and methods of measurements for Broadband Data
Transmission System equipment including the associated ancillary equipment in respect of electromagnetic
compatibility, as detailed in table 1.
Technical specifications related to the antenna port and emissions from the enclosure port of the radio equipment are
not included in the present document. Such technical specifications are found in the relevant product standards for the
effective...view more

IEC 62801:2020 specifies a measurement method of half-wavelength voltage applicable to Mach-Zehnder optical modulators in wireless communication and broadcasting systems. In addition, this method is also effective for the estimation of the intermodulation distortion of Mach-Zehnder optical modulators. The method applies for the following:
– frequency range: 10 MHz to 30 GHz;
– wavelength band: 0,8 µm to 2,0 µm;
– electro-optic material based Mach-Zehnder optical modulators and their modules.

The present document specifies technical characteristics and methods of measurements for Radio Frequency
Identification (RFID) devices used in the frequency ranges 865 MHz to 868 MHz and 915 MHz to 921 MHz.
Power limits up to a maximum of 2 W e.r.p. are specified for this equipment in the frequency band 865 MHz to
868 MHz and up to a maximum of 4 W e.r.p. in the frequency band 915 MHz to 921 MHz.
NOTE 1: The term frequency band is typically used for reference to dedicated bands as described ...view more

The objective is to analyse the security issues that can occur at the GNSS SIS level. In order to do so, a full taxonomy of the GNSS SIS attacks are proposed and GNSS SIS attack security model are elaborated and classified. Security metrics for the validation of the GBPT robustness performances are defined.
The proposed methodology for this technical report consists in three distinct steps that are described hereunder:
I. The first step consists in providing a full taxonomy of the possible GNS...view more

IEC TR 63099-2:2020 provides information about the current and latest applications for electric-field measurement that use radio-over-fibre technologies. System configurations, specifications, and measurement examples of each electric-field measurement system are included. The theoretical background of electric-field measurement and calibration method of electric-field sensors are beyond the scope of this document.

The present document defines an information model and protocol for generalized reconfigurable radio frequency
interface for reconfigurable REs except for reconfigurable mobile devices which are covered in [i.7] to [i.12]. The work
is based on the Use Cases defined in ETSI TR 103 585 [i.1], on the system requirements defined in ETSI
EN 303 641 [1] and on the radio reconfiguration related architecture for reconfigurable RE defined in ETSI
EN 303 648 [i.2].
The present document will be based o...view more

The present document covers the technical requirements for radio transmitters and receivers used in stations in the
Private Mobile Radio (PMR) service.
It applies to use in the land mobile service, operating on radio frequencies between 30 MHz and 1 GHz, with channel
separations of 12,5 kHz, 20 kHz and 25 kHz, intended for speech and/or data.
It applies to equipment for continuous and/or discontinuous transmission of data and/or digital speech.
The equipment comprises a transmitter and asso...view more

The present document defines an information model and protocol for multiradio interface for reconfigurable RE except
for reconfigurable mobile devices which are covered in [i.6] to [i.11]. The work is based on the Use Cases defined in
ETSI TR 103 585 [i.1], on the system requirements defined in ETSI EN 303 641 [1] and on the radio reconfiguration
related architecture for reconfigurable RE defined in ETSI EN 303 648 [i.2].
The present document is based on ETSI EN 303 146-1 [i.8] and provide a...view more

The scope of the present document is to define the generalized Radio Programming Interface (gRPI) for radio
equipment reconfiguration except for reconfigurable mobile devices which are covered in [i.4] to [i.9]. The work is
based on the Use Cases defined in ETSI TR 103 585 [i.1], on the system requirements defined in ETSI EN 303 641 [1]
and on the radio reconfiguration related architecture for radio equipment defined in ETSI EN 303 648 [i.2].
The present document will be based on ETSI EN 303...view more

The scope of the present document is to define the radio reconfiguration related architecture for reconfigurable Radio
Equipment except for reconfigurable mobile devices which are covered in ETSI EN 303 095 [i.4], ETSI
EN 302 969 [i.9] to ETSI EN 303 146-4 [i.13]. The work is based on the system requirements defined in ETSI
EN 303 641 [1] and the Use Cases defined in ETSI TR 103 062 [i.1], ETSI TR 102 944 [i.2], ETSI TR 103 585 [i.3].

The scope of the present document is to define an information model and protocol for unified radio application interface
for radio equipment reconfiguration except for reconfigurable mobile devices which are covered in [i.6] to [i.11]. The
work is based on the Use Cases defined in ETSI TR 103 585 [i.1], on the system requirements defined in ETSI
EN 303 641 [1] and on the radio reconfiguration related architecture for reconfigurable RE defined in ETSI
EN 303 648 [i.2].
The present document w...view more

The present document applies to the following radio equipment type:
• User Equipment for IMT-2000 CDMA Direct Spread (UTRA FDD).
The present document covers requirements for UTRA FDD User Equipment from 3GPP™ Releases 99, 4, 5, 6, 7, 8, 9,
10 and 11 defined in ETSI TS 125 101 [4]. This includes the requirements for UE operating bands from 3GPP™
Release 12 defined in ETSI TS 125 101 [4]. In addition, the present document covers requirements for UTRA FDD
User Equipment in the operating bands ...view more

The scope of the present document is to define the high level system requirements for reconfigurable Radio Equipment
enabling the provision of Radio Applications except for reconfigurable mobile devices which are covered in ETSI
EN 302 969 [i.4], ETSI EN 303 095 [i.5], ETSI EN 303 146 parts 1 [i.6] to 4 [i.9]. The work is based on the Use Cases
defined in ETSI TR 103 062 [i.1], ETSI TR 102 944 [i.2], ETSI TR 103 585 [i.3] and ETSI EN 302 969 [i.4].