Protective equipment for use in ice hockey - Part 1: General requirements (ISO 10256-1:2016)

ISO 10256-1:2016 is part of ISO 10256 specifies general requirements for head, face, neck and body protectors (hereafter referred to as protectors) for use in ice hockey.
ISO 10256-1:2016 is intended only for protectors used for ice hockey. Requirements are given for the following:
a)    terms and definitions;
b)    innocuousness;
c)    ergonomics;
d)    test report;
e)    permanent markings;
f)     information for users.
In the ISO 10256 series, collateral standards specify performance requirements for protectors for use in ice hockey and are intended to be read in conjunction with ISO 10256-1:2016.
NOTE 1       The requirements of a clause take precedence over a figure.
NOTE 2       The intent is to reduce the risk of injury to an ice hockey player without compromising the form or appeal of the game. These standards presume that the rules of play for ice hockey will be followed by players and enforced by officials.

Schutzausrüstung zum Gebrauch beim Eishockey - Teil 1: Allgemeine Anforderungen (ISO 10256-1:2016)

Équipements de protection destinés à être utilisés en hockey sur glace - Partie 1: Exigences générales (ISO 10256-1:2016)

ISO 10256-1:2016 spécifie les exigences générales relatives aux protections de la tête, du visage, du cou et du corps (ci-après dénommées «protections») destinées à être utilisées en hockey sur glace.
ISO 10256-1:2016 concerne uniquement les protections utilisées en hockey sur glace. Elle établit des exigences dans les domaines suivants:
a)    termes et définitions;
b)    innocuité;
c)    ergonomie;
d)    rapport d'essai;
e)    marquages permanents;
f)     informations destinées à l'utilisateur.
Les normes collatérales de la série ISO 10256 spécifient les exigences de performance applicables aux protections destinées à être utilisées en hockey sur glace et doivent être lues en complément de l'ISO 10256-1:2016.
NOTE 1       Les exigences d'un article prévalent sur celles d'une figure.
NOTE 2       L'objectif est de réduire le risque de blessure pour les joueurs de hockey sur glace sans compromettre pour autant l'aspect ou l'attrait même du jeu. Ces normes présupposent que les règles du hockey sur glace seront respectées par les joueurs et appliquées par les arbitres.

Varovalna oprema za uporabo pri hokeju na ledu - 1. del: Splošne zahteve (ISO 10256-1:2016)

Ta del standarda ISO 10256 določa splošne zahteve za ščitnike za glavo, obraz, vrat in telo (v nadaljnjem besedilu »ščitniki«) za uporabo pri hokeju na ledu.
Ta del standarda ISO 10256 je namenjen samo za ščitnike, ki se uporabljajo pri hokeju na ledu. Navedene so zahteve za naslednje:
a) izrazi in definicije;
b) neškodljivost;
c) ergonomija;
d) preskusno poročilo;
e) stalne oznake;
f) informacije za uporabnike.
Spremljevalni standardi skupine standardov ISO 10256 določajo zahteve glede učinkovitosti za ščitnike za uporabo pri hokeju na ledu in jih je treba brati v povezavi s tem delom standarda ISO 10256.
OPOMBA 1: Zahteve točke imajo prednost pred številsko vrednostjo.
OPOMBA 2: Namen je zmanjšati tveganje za poškodbe igralcev hokeja brez ogrožanja načina ali privlačnosti igre. Ti standardi predvidevajo, da bodo igralci upoštevali pravila igre hokeja na ledu ter da jih bodo sodniki uveljavljali.

General Information

Status
Published
Publication Date
13-Dec-2016
Withdrawal Date
29-Jun-2017
Current Stage
6060 - Definitive text made available (DAV) - Publishing
Start Date
14-Dec-2016
Completion Date
14-Dec-2016

Relations

Buy Standard

Standard
EN ISO 10256-1:2017
English language
15 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN ISO 10256-1:2017
01-marec-2017
1DGRPHãþD
SIST EN ISO 10256:2003
Varovalna oprema za uporabo pri hokeju na ledu - 1. del: Splošne zahteve (ISO
10256-1:2016)
Protective equipment for use in ice hockey - Part 1: General requirements (ISO 10256-
1:2016)
Schutzausrüstung zur Benutzung beim Eishockey - Teil 1: Allgemeine Anforderungen
(ISO 10256-1:2016)
Protections de tête et de visage destinées à être utilisées en hockey sur glace - Partie 1:
Exigences générales (ISO 10256-1:2016)
Ta slovenski standard je istoveten z: EN ISO 10256-1:2016
ICS:
13.340.20 Varovalna oprema za glavo Head protective equipment
97.220.20 Oprema za zimske športe Winter sports equipment
SIST EN ISO 10256-1:2017 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN ISO 10256-1:2017

---------------------- Page: 2 ----------------------

SIST EN ISO 10256-1:2017


EN ISO 10256-1
EUROPEAN STANDARD

NORME EUROPÉENNE

December 2016
EUROPÄISCHE NORM
ICS 13.340.20 Supersedes EN ISO 10256:2003
English Version

Protective equipment for use in ice hockey - Part 1:
General requirements (ISO 10256-1:2016)
Équipements de protection destinés à être utilisés en Schutzausrüstung zum Gebrauch beim Eishockey - Teil
hockey sur glace - Partie 1: Exigences générales (ISO 1: Allgemeine Anforderungen (ISO 10256-1:2016)
10256-1:2016)
This European Standard was approved by CEN on 17 September 2016.

CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this
European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references
concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN
member.

This European Standard exists in three official versions (English, French, German). A version in any other language made by
translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management
Centre has the same status as the official versions.

CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia,
Finland, Former Yugoslav Republic of Macedonia, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania,
Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and
United Kingdom.





EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION

EUROPÄISCHES KOMITEE FÜR NORMUNG

CEN-CENELEC Management Centre: Avenue Marnix 17, B-1000 Brussels
© 2016 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN ISO 10256-1:2016 E
worldwide for CEN national Members.

---------------------- Page: 3 ----------------------

SIST EN ISO 10256-1:2017
EN ISO 10256-1:2016 (E)
Contents Page
European foreword . 3
Annex ZA (informative) Relationship between this European Standard and the Essential
Requirements of EU Directive 89/686/EEC Personal Protective Equipment . 4

2

---------------------- Page: 4 ----------------------

SIST EN ISO 10256-1:2017
EN ISO 10256-1:2016 (E)
European foreword
This document (EN ISO 10256-1:2016) has been prepared by Technical Committee ISO/TC 85 "Sports
and other recreational facilities and equipment" in collaboration with Technical Committee
CEN/TC 158 “Head protection” the secretariat of which is held by BSI.
This European Standard shall be given the status of a national standard, either by publication of an
identical text or by endorsement, at the latest by June 2017, and conflicting national standards shall be
withdrawn at the latest by June 2017.
Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CEN [and/or CENELEC] shall not be held responsible for identifying any or all such patent
rights.
This document supersedes EN ISO 10256:2003.
This document has been prepared under a mandate given to CEN by the European Commission and the
European Free Trade Association, and supports essential requirements of EU Directive(s).
For relationship with EU Directive(s), see informative Annex ZA, which is an integral part of this
document.
According to the CEN-CENELEC Internal Regulations, the national standards organizations of the
following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria,
Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia,
France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.