EN 50467:2011
(Main)Railway applications - Rolling stock - Electrical connectors, requirements and test methods
Railway applications - Rolling stock - Electrical connectors, requirements and test methods
This European Standard retains EN 61984:2001 as the minimum performance requirements for railway rolling stock electrical connectors. It identifies additional terms, test methods and performance requirements for single-pole and multipole connectors with rated voltages up to 1 000 V, rated currents up to 125 A per contact and frequencies below 3 MHz used for indoor and outdoor applications in railway rolling stock. This European Standard identifies the application levels for electrical connectors based on - the severity of the service conditions in different rolling stock technologies, - the intended use of the rolling stock, - the location of the connector in the rolling stock system. This European Standard is not applicable to internal connections of electronic devices such as connectors for printed boards and rack-and-panel connectors.
Bahnanwendungen - Fahrzeuge - Elektrische Steckverbinder, Bestimmungen und Prüfverfahren
Applications ferroviaires - Matériel roulant - Connecteurs électriques, exigences et méthodes d'essai
Železniške naprave - Železniška vozila - Konektorji, zahteve in preskusne metode
Ta evropski standard kot najnižjo zahtevo glede zmogljivosti konektorjev železniških vozil ohranja standard EN 61984 2001.
Opredeljuje dodatne pogoje, preskusne metode in zahteve glede zmogljivosti za enopolne in večpolne konektorje z nazivnimi napetostmi do 1000 V, nazivnimi toki do 125 A na stik in frekvencami pod 3 MHz, ki se uporabljajo za notranje in zunanje naprave pri železniških vozilih.
Ta evropski standard opredeljuje ravni naprav za konektorje na podlagi
– resnosti pogojev obratovanja pri različnih tehnologijah železniških vozil,
– predvidene uporabe železniških vozil,
– namestitve konektorja v sistemu železniških vozil.
Ta evropski standard se ne uporablja za notranje povezave elektronskih naprav, kot so konektorji za tiskana vezja ter konektorji za stojala in plošče.
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 50467:2012
01-februar-2012
1DGRPHãþD
SIST-TS CLC/TS 50467:2008
Železniške naprave - Železniška vozila - Konektorji, zahteve in preskusne metode
Railway applications - Rolling stock - Electrical connectors, requirements and test
methods
Bahnanwendungen - Fahrzeuge - Elektrische Steckverbinder, Bestimmungen und
Prüfverfahren
Applications ferroviaires - Matériel roulant - Connecteurs électriques, exigences et
méthodes d'essai
Ta slovenski standard je istoveten z: EN 50467:2011
ICS:
31.220.10 9WLþLLQYWLþQLFHNRQHNWRUML Plug-and-socket devices.
Connectors
45.060.01 Železniška vozila na splošno Railway rolling stock in
general
SIST EN 50467:2012 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 50467:2012
---------------------- Page: 2 ----------------------
SIST EN 50467:2012
EUROPEAN STANDARD
EN 50467
NORME EUROPÉENNE
December 2011
EUROPÄISCHE NORM
ICS 29.120.30; 45.060.01 Supersedes CLC/TS 50467:2008 + corr. May.2008
English version
Railway applications -
Rolling stock -
Electrical connectors, requirements and test methods
Applications ferroviaires - Bahnanwendungen -
Matériel roulant - Fahrzeuge -
Connecteurs électriques, exigences et Elektrische Steckverbinder,
méthodes d'essai Bestimmungen und Prüfverfahren
This European Standard was approved by CENELEC on 2011-10-10. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia,
Spain, Sweden, Switzerland and the United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Management Centre: Avenue Marnix 17, B - 1000 Brussels
© 2011 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 50467:2011 E
---------------------- Page: 3 ----------------------
SIST EN 50467:2012
EN 50467:2011 – 2 –
Contents
Foreword . 4
Introduction . 5
1 Scope . 6
2 Normative references . 6
3 Terms and definitions . 8
4 Technical information (electrical ratings) . 14
5 Classification . 14
5.1 General . 14
5.2 Severity of service conditions in different rolling stock technologies . 14
5.3 Intended use of rolling stock . 14
5.4 Location of connector on board rolling stock . 15
6 Requirements . 17
6.1 General .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.