Incandescent lamps - Safety specifications - Part 3: Tungsten-halogen lamps (non-vehicle)

IEC 60432-3:2012 specifies the safety requirements for single-capped and double-capped tungsten halogen lamps, having rated voltages of up to 250 V, used for the following applications: - projection (including cinematograph and still projection), - photographic (including studio), - floodlighting, - special purpose, - general purpose, - stage lighting. This second edition of IEC 60432-3 cancels and replaces the first edition published in 2002, Amendment 1 (2005) and Amendment 2 (2008). The main changes with respect to the previous edition are as follows: - adapting the cold fill pressure requirements and tests for self-shielded lamps to the state of the technology, - introduction of requirements to fully cover photobiological safety according to IEC 62471.

Glühlampen - Sicherheitsanforderungen - Teil 3: Halogen-Glühlampen (Fahrzeuglampen ausgenommen)

Lampes à incandescence - Prescriptions de sécurité - Partie 3: Lampes tungstène-halogène (véhicules exceptés)

La CEI 60432-3:2012 fournit les exigences de sécurité relatives aux lampes tungstène-halogène à culot unique et à celles à deux culots, ayant des tensions assignées jusqu'à 250 V, utilisées pour les applications suivantes: - projection (y compris cinéma et projection statique), - photographie (y compris prise de vues), - illumination, - usage special, - usage general, - éclairage de scène. Cette deuxième édition de la 60432-3 annule et remplace la première édition parue en 2002, l'Amendement 1 (2005) et l'Amendement 2 (2008). Par rapport à l'édition précédente, les changements principaux sont les suivants: - la mise à jour des exigences et essais concernant la pression à froid pour les lampes à écran intégré conformément à l'état de l'art de la technologie, - l'introduction des exigences pour couvrir intégralement la sécurité photobiologique en conformité avec la CEI 62471.

Sijalke - Varnostne zahteve - 3. del: Halogenske sijalke (razen za vozila)

Ta del standarda IEC 60432 določa varnostne zahteve za halogenske sijalke z enim ali dvema vznožkoma, ki imajo nazivne napetosti do 250 V in se uporabljajo za:
• projekcijo (vključno s kinematografsko projekcijo in projekcijo slik),
• fotografijo (vključno s studiem),
• reflektorsko osvetlitev,
• posebne namene,
• splošne namene,
• odrsko razsvetljavo.
Ta mednarodni standard ne velja za halogenske sijalke z enim vznožkom za splošne namene, ki so obravnavane v standardu IEC 60432-2 in se uporabljajo kot zamenjava za konvencionalne sijalke. Ta del standarda IEC 60432 zajema fotobiološko varnost glede na standarda IEC 62471 in IEC/TR 62471-2. Sijalke, ki jih zajema ta del standarda IEC 60432, ne dosegajo ravni tveganja, ki zahteva, da so označene kot tvegana skupina, če so
a) sijalke za reflektorsko osvetlitev,
b) kapsulske sijalke za splošne namene ali
c) reflektorske sijalke za splošne namene.

General Information

Status
Published
Publication Date
17-Jan-2013
Withdrawal Date
07-Aug-2015
Current Stage
6060 - Document made available - Publishing
Start Date
18-Jan-2013
Completion Date
18-Jan-2013

Relations

Buy Standard

Standard
EN 60432-3:2013
English language
35 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)

SLOVENSKI STANDARD
SIST EN 60432-3:2013
01-julij-2013
1DGRPHãþD
SIST EN 60432-3:2004
SIST EN 60432-3:2004/A1:2006
SIST EN 60432-3:2004/A2:2008
Sijalke - Varnostne zahteve - 3. del: Halogenske sijalke (razen za vozila)
Incandescent lamps - Safety specifications - Part 3: Tungsten-halogen lamps (non-
vehicle)
Glühlampen - Sicherheitsanforderungen - Teil 3: Halogen-Glühlampen (Fahrzeuglampen
ausgenommen)
Lampes à incandescence - Prescriptions de sécurité - Partie 3: Lampes tungstène-
halogène (véhicules exceptés)
Ta slovenski standard je istoveten z: EN 60432-3:2013
ICS:
29.140.20 Žarnice z žarilno nitko Incandescent lamps
SIST EN 60432-3:2013 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

---------------------- Page: 1 ----------------------

SIST EN 60432-3:2013

---------------------- Page: 2 ----------------------

SIST EN 60432-3:2013

EUROPEAN STANDARD
EN 60432-3

NORME EUROPÉENNE
January 2013
EUROPÄISCHE NORM

ICS 29.140.20 Supersedes EN 60432-3:2003 + A1:2005 + A2:2008


English version


Incandescent lamps -
Safety specifications -
Part 3: Tungsten-halogen lamps (non-vehicle)
(IEC 60432-3:2012)


Lampes à incandescence -  Glühlampen -
Prescriptions de sécurité - Sicherheitsanforderungen -
Partie 3: Lampes tungstène-halogène Teil 3: Halogen-Glühlampen
(véhicules exceptés) (Fahrzeuglampen ausgenommen)
(CEI 60432-3:2012) (IEC 60432-3:2012)





This European Standard was approved by CENELEC on 2012-08-08. CENELEC members are bound to comply
with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard
the status of a national standard without any alteration.

Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the CEN-CENELEC Management Centre or to any CENELEC member.

This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and notified
to the CEN-CENELEC Management Centre has the same status as the official versions.

CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,
the Czech Republic, Denmark, Estonia, Finland, Former Yugoslav Republic of Macedonia, France, Germany,
Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland,
Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey and the United Kingdom.

CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung

Management Centre: Avenue Marnix 17, B - 1000 Brussels


© 2013 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60432-3:2013 E

---------------------- Page: 3 ----------------------

SIST EN 60432-3:2013
EN 60432-3:2013 - 2 -
Foreword
The text of document 34A/1567/FDIS, future edition 2 of IEC 60432-3, prepared by SC 34A "Lamps"
of IEC/TC 34 "Lamps and related equipment", was submitted to the IEC-CENELEC parallel vote and
approved by CENELEC as EN 60432-3:2013.
The following dates are fixed:
(dop) 2013-07-18
• latest date by which the document has
to be implemented at national level by
publication of an identical national
standard or by endorsement
(dow) 2015-08-08
• latest date by which the national
standards conflicting with the
document have to be withdrawn

This document supersedes EN 60432-3:2003 + A1:2005 + A2:2008.

EN 60432-3:2013 includes the following significant technical changes with respect to
EN 60432-3:2003 + A1:2005 + A2:2008:
- adapting the cold fill pressure requirements and tests for self-shielded lamps to the state of the
technology;
- introduction of requirements to fully cover photobiological safety according to EN 62471.

Attention is drawn to the possibility that some of the elements of this document may be the subject of
patent rights. CENELEC [and/or CEN] shall not be held responsible for identifying any or all such
patent rights.

This standard covers the Principle Elements of the Safety Objectives for Electrical Equipment
Designed for Use within Certain Voltage Limits (LVD - 2006/95/EC).
Endorsement notice
The text of the International Standard IEC 60432-3:2012 was approved by CENELEC as a European
Standard without any modification.
In the official version, for Bibliography, the following notes have to be added for the standards indicated:

IEC 60127-2 NOTE Harmonised as EN 60127-2.
IEC 60269-3 NOTE Harmonised as HD 60269-3.
IEC 60335-2-56:2002 NOTE Harmonised as EN 60335-2-56:2003 (not modified).
IEC 60432-2:1999 NOTE Harmonised as EN 60432-2:2000 (modified).
IEC 60432-2:1999/A
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.