EN 62562:2011

Cavity resonator method to measure the complex permittivity of low-loss dielectric plates

IEC 62562:2010(E) describes a measurement method of dielectric properties in the planar direction of dielectric plate at microwave frequency. It has been created in order to develop new materials and to design microwave active and passive devices for which standardization of measurement methods of material properties is more and more important. It has the following characteristics: - the relative permittivity ε′ and loss tangent tanδ values of a dielectric plate sample can be measured accurately and non-destructively; - temperature dependence of complex permittivity can be measured; the measurement accuracy is within 0,3 % for ε′ and within 5 x 10-6 for tanδ; - fringing effect is corrected using correction charts calculated on the basis of rigorous analysis. It is applicable for the measurements on the following condition: - frequency: 2 GHz -6 -2. This first edition cancels and replaces the PAS published in 2008.

Hohlraumresonanzverfahren zum Messen der komplexen Permittivität von verlustarmen dielektrischen Platten

Méthode de la cavité résonante pour mesurer la permittivité complexe des plaques diélectriques à faibles pertes

IEC 62562:2010 décrit une méthode de mesure des propriétés diélectriques en hyperfréquence dans la direction du plan d'une plaque diélectrique. Cette méthode est appelée méthode de la cavité résonante. Elle a été créée pour élaborer de nouveaux matériaux et pour concevoir des dispositifs micro-ondes actifs et passifs pour lesquels la normalisation des méthodes de mesure des propriétés des matériaux est de plus en plus importante. La présente version bilingue, publiée en 2010-05, correspond à la version anglaise. Cette publication indique qu'elle contient des couleurs qui sont considérées comme utiles à une bonne compréhension de son contenu.

Metoda z votlinskim resonatorjem za merjenje kompleksne permitivnosti nizkoizgubnih dielektričnih plošč (IEC 62562:2010)

Namen tega mednarodnega standarda je opisati merilno metodo za dielektrične lastnosti v ravninski smeri dielektrične plošče pri mikrovalovni frekvenci. Ta metoda se imenuje metoda z votlinskim resonatorjem. Oblikovana je bila za razvoj novih materialov in zasnovo mikrovalovnih aktivnih in pasivnih naprav, pri katerih je standardizacija merilnih metod lastnosti materialov vse pomembnejša.

General Information

• Status: Published
• Publication Date: 17-Feb-2011
• Withdrawal Date: 01-Jan-2014
• ICS: 17.220 - Electricity. Magnetism. Electrical and magnetic measurements
• Technical Committee: CLC/SR 46F - RF and microwave passive components
• Drafting Committee: IEC/SC 46F - IEC_SC_46F
• Parallel Committee: IEC/SC 46F - IEC_SC_46F
• Current Stage: 6060 - Document made available - Publishing
• Start Date: 18-Feb-2011
• Completion Date: 18-Feb-2011
• Ref Project: SIST EN 62562:2011 - Cavity resonator method to measure the complex permittivity of low-loss dielectric plates (IEC 62562:2010)

Standards Content (Sample)

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.RVWLHohlraumresonanzverfahren zum Messen der komplexen Permittivität von verlustarmen dielektrischen Platten (IEC 62562:2010)Méthode de la cavité résonante pour mesurer la permittivité complexe des plaques diélectriques à faibles pertes (CEI 62562:2010)Cavity resonator method to measure the complex permittivity of low-loss dielectric plates (IEC 62562:2010)17.220.20Measurement of electrical and magnetic quantitiesICS:Ta slovenski standard je istoveten z:EN 62562:2011SIST EN 62562:2011en01-april-2011SIST EN 62562:2011SLOVENSKI
STANDARD



SIST EN 62562:2011



EUROPEAN STANDARD EN 62562 NORME EUROPÉENNE
EUROPÄISCHE NORM February 2011
CENELEC European Committee for Electrotechnical Standardization Comité Européen de Normalisation Electrotechnique Europäisches Komitee für Elektrotechnische Normung
Management Centre: Avenue Marnix 17, B - 1000 Brussels
© 2011 CENELEC -
All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 62562:2011 E
ICS 17.220
English version
Cavity resonator method to measure the complex permittivity
of low-loss dielectric plates (IEC 62562:2010)
Méthode de la cavité résonante pour mesurer la permittivité complexe des plaques diélectriques à faibles pertes (CEI 62562:2010)
Hohlraumresonanzverfahren zum Messen der komplexen Permittivität von verlustarmen dielektrischen Platten (IEC 62562:2010)
This European Standard was approved by CENELEC on 2011-01-02. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus, the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom.
SIST EN 62562:2011



EN 62562:2011 - 2 -
Foreword The text of document 46F/118/CDV, future edition 1 of IEC 62562, prepared by SC 46F, R.F. and microwave passive components, of IEC TC 46, Cables, wires, waveguides, R.F. connectors, R.F. and microwave passive components and accessories, was submitted to the IEC-CENELEC parallel vote and was approved by CENELEC as EN 62562 on 2011-01-02. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN and CENELEC shall not be held responsible for identifying any or all such patent rights. The following dates were fixed: – latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement
(dop)
2011-10-02 – latest date by which the national standards conflicting
with the EN have to be withdrawn
(dow)
2014-01-02 Endorsement notice The text of the International Standard IEC 62562:2010 was approved by CENELEC as a European Standard without any modification. __________
SIST EN 62562:2011



IEC 62562Edition 1.0 2010-02INTERNATIONAL STANDARD
Cavity resonator method to measure the complex permittivity of low-loss dielectric plates
INTERNATIONAL ELECTROTECHNICAL COMMISSION RICS 17.220 PRICE CODEISBN 978-2-88910-763-6
® Registered trademark of the International Electrotechnical Commission ® SIST EN 62562:2011 colourinside



– 2 – 62562 © IEC:2010(E) CONTENTS FOREWORD.3 1 Scope.5 2 Measurement parameters.5 3 Theory and calculation equations.6 3.1 Relative permittivity and loss tangent.6 3.2 Temperature dependence of ε′ and δtan.9 3.3 Cavity parameters.10 4 Measurement equipment and apparatus.11 4
...