ISO 11243:2023
(Main)Cycles — Luggage carriers for bicycles — Requirements and test methods
Cycles — Luggage carriers for bicycles — Requirements and test methods
This document specifies safety and performance requirements for the design and testing of both non cycle specific luggage carriers intended for mounting (with or without tools) and cycle specific luggage carriers mounted on complete cycles. It applies to luggage carriers intended to be positioned above and adjacent to the wheels of cycles. This document lays down guidelines for instructions on the use and care of such luggage carriers. This document does not apply to removable luggage (for example, handlebar bags or baskets that are not permanently attached). Toy carrier intended to be mounted on bicycles for young children in the scope of ISO 8098 are not covered by this document.
Cycles — Porte-bagages pour bicyclettes — Exigences et méthodes d'essai
Le présent document spécifie les exigences de sécurité et de performance pour la conception et les essais de porte-bagages non spécifiques aux cycles et destinés à être montés (avec ou sans outils), et de porte-bagages spécifiques aux cycles montés sur des cycles complets. Il s’applique aux porte-bagages destinés à être positionnés au-dessus et à côté des roues de cycles. Ce document établit des lignes directrices pour les instructions relatives à l'utilisation et à l'entretien de ces porte-bagages. Le présent document ne concerne pas les bagages amovibles (par exemple des sacs de guidon ou des paniers qui ne sont pas fixés en permanence). Les porte-bagages jouet destinés à être montés sur les bicyclettes pour jeunes enfants entrant dans le domaine d’application de la norme ISO 8098 ne sont pas couverts par le présent document.
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 11243
Third edition
2023-09
Cycles — Luggage carriers for bicycles
— Requirements and test methods
Cycles — Porte-bagages pour bicyclettes — Exigences et méthodes
d'essai
Reference number
ISO 11243:2023(E)
© ISO 2023
---------------------- Page: 1 ----------------------
ISO 11243:2023(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2023
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on
the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below
or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii
© ISO 2023 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 11243:2023(E)
Contents Page
Foreword .v
Introduction . vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 The restrictions of maximum load capacity for the types of non cycle specific
luggage carrier . 3
5 Requirements and test methods . 4
5.1 General . 4
5.2 Tolerances . 4
5.3 Crack detection methods . . 5
5.4 Sharp edges . 5
5.5 Security of safety-related fasteners . 5
5.5.1 Security of screws . 5
5.5.2 Minimum failure torque . 5
5.6 Minimum requirements for rear luggage carriers to which a child seat could be
attached . 5
5.7 Protrusions . 5
5.8 Rear luggage carriers — Provision for lighting . 5
5.9 Dynamic load tests . . 6
5.9.1 Requirement .
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.