Magnesium and magnesium alloys — Wrought magnesium and magnesium alloys

This document specifies the chemical composition and mechanical properties of magnesium and magnesium alloys for wrought products in the form of bars and solid sections, tubes and hollow sections, forgings, and plate and sheet.

Magnésium et alliages de magnésium — Magnésium et alliages de magnésium corroyés

General Information

Status
Published
Publication Date
08-May-2019
Current Stage
9020 - International Standard under periodical review
Start Date
15-Apr-2024
Completion Date
15-Apr-2024
Ref Project

Relations

Buy Standard

Standard
ISO 3116:2019 - Magnesium and magnesium alloys -- Wrought magnesium and magnesium alloys
English language
30 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 3116
Fifth edition
2019-05
Magnesium and magnesium alloys —
Wrought magnesium and magnesium
alloys
Magnésium et alliages de magnésium — Magnésium et alliages de
magnésium corroyés
Reference number
ISO 3116:2019(E)
©
ISO 2019

---------------------- Page: 1 ----------------------
ISO 3116:2019(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 3116:2019(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Designation . 1
4.1 Material . 1
4.2 Temper designation . 2
4.3 Designations of product form . 3
4.4 Designation for ordering . 3
5 Requirements . 3
5.1 Chemical composition . 3
5.2 Mechanical properties . 3
5.3 Frequency of testing . 3
6 Sampling . 3
7 Test pieces . 3
8 Test methods . 4
8.1 Chemical composition . 4
8.2 Tensile test .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.