Cryogenic vessels — Transportable vacuum insulated vessels of not more than 1 000 litres volume — Part 1: Design, fabrication, inspection and tests

ISO 21029-1:2018 specifies requirements for the design, fabrication, type test and initial inspection and test of transportable vacuum-insulated cryogenic pressure vessels of not more than 1 000 l volume. This document applies to transportable vacuum-insulated cryogenic vessels for fluids as specified in 3.1 and Table 1 and does not apply to such vessels designed for toxic fluids. NOTE 1 This document does not cover specific requirements for refillable liquid hydrogen and LNG tanks that are primarily dedicated as fuel tanks in vehicles. For fuel tanks used in land and marine vehicles, see ISO 13985. NOTE 2 Specific requirements for open top dewards are not covered by this document.

Récipients cryogéniques — Récipients transportables, isolés sous vide, d'un volume n'excédant pas 1 000 litres — Partie 1: Conception, fabrication, inspection et essais

General Information

Status
Published
Publication Date
15-Feb-2018
Current Stage
9092 - International Standard to be revised
Completion Date
28-Sep-2023
Ref Project

Relations

Buy Standard

Standard
ISO 21029-1:2018 - Cryogenic vessels -- Transportable vacuum insulated vessels of not more than 1 000 litres volume
English language
90 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 21029-1
Second edition
2018-02
Cryogenic vessels — Transportable
vacuum insulated vessels of not more
than 1 000 litres volume —
Part 1:
Design, fabrication, inspection and
tests
Récipients cryogéniques — Récipients transportables, isolés sous vide,
d'un volume n'excédant pas 1 000 litres —
Partie 1: Conception, fabrication, inspection et essais
Reference number
ISO 21029-1:2018(E)
©
ISO 2018

---------------------- Page: 1 ----------------------
ISO 21029-1:2018(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 21029-1:2018(E)

Contents Page
Foreword .v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Symbols . 5
5 General requirements . 6
6 Mechanical loads . 7
6.1 General . 7
6.2 Load during the pressure test . 7
6.3 Other mechanical loads . 7
7 Chemical effects . 8
8 Thermal conditions . 8
9 Material . 8
9.1 General . 8
9.2 Material properties . 8
9.3 Inspection certificate . 9
9.4 Materials for outer jackets and equipment . 9
10 Design .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.