Optics and photonics — Guidance for the selection of environmental tests

ISO 10109:2015 contains tables for environmental tests and test parameters which can be used as a guideline for the selection of environmental tests. These include the selection of standardized tests according to ISO 9022 as well as additional parameters not described in ISO 9022 and necessary for the optical or photonic instruments. Ultimately, these tables specify the requirements to be met with regard to the reliability of the optical, mechanical, chemical, and electrical properties or performance characteristics of the instruments when exposed to environmental influences.

Optiques et photonique — Directives relatives au choix des essais environnementaux

General Information

Status
Withdrawn
Publication Date
03-Jun-2015
Current Stage
9599 - Withdrawal of International Standard
Completion Date
06-Feb-2024
Ref Project

Relations

Buy Standard

Standard
ISO 10109:2015 - Optics and photonics -- Guidance for the selection of environmental tests
English language
16 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 10109
Second edition
2015-06-01
Optics and photonics — Guidance for
the selection of environmental tests
Optiques et photonique — Directives relatives au choix des essais
environnementaux
Reference number
ISO 10109:2015(E)
©
ISO 2015

---------------------- Page: 1 ----------------------
ISO 10109:2015(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2015, Published in Switzerland
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form
or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior
written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of
the requester.
ISO copyright office
Ch. de Blandonnet 8 • CP 401
CH-1214 Vernier, Geneva, Switzerland
Tel. +41 22 749 01 11
Fax +41 22 749 09 47
copyright@iso.org
www.iso.org
ii © ISO 2015 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 10109:2015(E)

Contents Page
Foreword .iv
Introduction .v
1 Scope . 1
2 Terms and definitions . 1
3 Environmental influences . 3
3.1 General . 3
3.2 Standard environment 1 . 3
3.3 Standard environment 2 . 3
3.4 Standard environment 3 . 4
3.5 Standard environment 4 . 4
3.6 Standard environment 5 . 5
3.7 Standard environment 6 . 5
4 Table for environmental tests and test parameters . 5
Annex A (informative) Example of selection of environmental tests .10
Bibliography .16
© ISO 2015 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 10109:2015(E)

Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of
electrotechnical standardization.
The procedures used to develop this document and those intended for its further maintenance are
described
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.