ISO/TS 17519:2019

Gas cylinders — Refillable permanently mounted composite tubes for transportation

This document specifies the minimum requirements for the material, design construction and workmanship, manufacturing processes, examination and testing at time of manufacture of an assembly of permanently mounted composite tube(s) in a frame with associated components. Tubes covered by the requirements of this document are: a) of composite construction, permanently mounted in a transport frame and suitable for specified service conditions, designated as: Type 3 — a fully wrapped tube with a seamless metallic liner and composite reinforcement on both the cylindrical part and the dome ends; or Type 4 — a fully wrapped tube with a non-load sharing liner and composite reinforcement on both the cylindrical part and the dome ends. b) with water capacities from 450 l up to and including 10 000 l; c) containing compressed gases but excluding: liquefied gases, dissolved gases, and gases and gas mixtures which are classified for transport as toxic or oxidizing; d) with working pressure up to 1 000 bar. This document does not address tubes with working pressure times water capacity (p × V) more than 3 000 000 bar∙l.

Bouteilles à gaz — Tubes composites rechargeables montés de façon permanente pour le transport

General Information

• Status: Published
• Publication Date: 06-Jun-2019
• ICS: 23.020.35 - Gas cylinders
• Technical Committee: ISO/TC 58/SC 3 - Cylinder design
• Drafting Committee: ISO/TC 58/SC 3/WG 35 - Permanently mounted composite tubes
• Current Stage: 9092 - International Standard to be revised
• Completion Date: 21-Mar-2024

Relations

• Replaces: ISO/FDIS 17519.2 - Gas cylinders — Refillable permanently mounted composite tubes for transportation
• Effective Date: 06-Jun-2022

Standards Content (Sample)

TECHNICAL ISO/TS
SPECIFICATION 17519
First edition
2019-06
Gas cylinders — Refillable
permanently mounted composite
tubes for transportation
Bouteilles à gaz — Tubes composites rechargeables montés de façon
permanente pour le transport
Reference number
ISO/TS 17519:2019(E)
©
ISO 2019

---------------------- Page: 1 ----------------------
ISO/TS 17519:2019(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved

---------------------- Page: 2 ----------------------
ISO/TS 17519:2019(E)

Contents Page
Foreword .v
Introduction .vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 3
4 Basis for the design requirements . 4
4.1 General . 4
4.2 Design life . 4
4.3 Design number of filling cycles . 4
4.4 Temperature range . 4
4.4.1 Gas temperature . 4
4.4.2 Tube material temperature . 4
4.5 Gas compatibility . 5
4.6 Prohibited gases . 5
4.7 External environment . 5
5 Conformity . 5
5.1 General . 5
5.2 Design documentation . 5
5.2.1 General.
...