ISO 13374-3:2012
(Main)Condition monitoring and diagnostics of machines — Data processing, communication and presentation — Part 3: Communication
Condition monitoring and diagnostics of machines — Data processing, communication and presentation — Part 3: Communication
This part of ISO 13374 specifies requirements for data communication for an open condition monitoring and diagnostics (CM&D) reference information architecture and for a reference processing architecture. Software design professionals require communications to be defined for exchange of CM&D information between software systems. This part of ISO 13374 facilitates the interoperability of CM&D systems.
Surveillance et diagnostic d'état des machines — Traitement, échange et présentation des données — Partie 3: Échange
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 13374-3
First edition
2012-02-15
Condition monitoring and diagnostics
of machines — Data processing,
communication and presentation —
Part 3:
Communication
Surveillance et diagnostic d’état des machines — Traitement, échange
et présentation des données —
Partie 3: Échange
Reference number
ISO 13374-3:2012(E)
©
ISO 2012
---------------------- Page: 1 ----------------------
ISO 13374-3:2012(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2012
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO’s
member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii © ISO 2012 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 13374-3:2012(E)
Contents Page
Foreword .iv
Introduction . v
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Open CM&D information architecture communication requirements . 1
4.1 Overview . 1
4.2 Reference data library communication requirements . 2
4.3 Communications initiation requirements . 2
4.4 Message content requirements . 2
5 Open CM&D processing architecture communication requirements . 2
5.1 Overview . 2
5.2 Diverse technologies and UML representation . 3
5.3 Interface types and general interaction . 4
5.4 Specific ISO 13374-2 interface method requirements . 7
5.5 Data provider specification support considerations . 8
[1]
Annex A (informative) Open CM&D information architecture based on IEC 62264-5 .10
Bibliography .21
© ISO 2012 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 13374-3:2012(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International
Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.