Transportable gas storage devices — Hydrogen absorbed in reversible metal hydride

This document defines the requirements applicable to the material, design, construction, and testing of transportable hydrogen gas storage systems, referred to as "metal hydride assemblies" (MH assemblies) which utilize shells not exceeding 150 l internal volume and having a maximum developed pressure (MDP) not exceeding 25 MPa. This document is applicable to refillable storage MH assemblies where hydrogen is the only transferred media. It is not applicable to storage MH assemblies intended to be used as fixed fuel-storage onboard hydrogen fuelled vehicles.

Appareils de stockage de gaz transportables — Hydrogène absorbé dans un hydrure métallique réversible

General Information

Status
Published
Publication Date
15-Aug-2018
Current Stage
9093 - International Standard confirmed
Completion Date
17-Apr-2024
Ref Project

Relations

Buy Standard

Standard
ISO 16111:2018 - Transportable gas storage devices -- Hydrogen absorbed in reversible metal hydride
English language
43 pages
sale 15% off
Preview
sale 15% off
Preview

Standards Content (Sample)

INTERNATIONAL ISO
STANDARD 16111
Second edition
2018-08
Transportable gas storage devices —
Hydrogen absorbed in reversible
metal hydride
Appareils de stockage de gaz transportables — Hydrogène absorbé
dans un hydrure métallique réversible
Reference number
ISO 16111:2018(E)
©
ISO 2018

---------------------- Page: 1 ----------------------
ISO 16111:2018(E)

COPYRIGHT PROTECTED DOCUMENT
© ISO 2018
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2018 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 16111:2018(E)

Contents Page
Foreword .v
Introduction .vi
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 2
4 Service conditions . 4
4.1 Pressures . 4
4.1.1 Maximum developed pressure (MDP) . 4
4.1.2 Rated charging pressure (RCP) . 4
4.1.3 Stress level at MDP . 4
4.2 Rated capacity . 4
4.3 Temperature ranges . 5
4.3.1 Operating temperature range . 5
4.3.2 Service temperature range . 5
4.4 Environmental conditions . 5
4.5 Service life . 5
4.6 Hydrogen quality . 5
4.7 Special service conditions . 5
5 Design considerations . 5
5.1 General .
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.