SIST EN 303 213-5-1 V1.1.1:2020

SLOVENSKI STANDARD
oSIST prEN 303 213-5-1 V1.0.0:2020
01-februar-2020
Napredni sistem za vodenje in nadzor gibanja po zemlji (A-SMGCS) - 5. del:
Harmonizirani standard za dostop do radijskega spektra za večplastno (MLAT)
opremo - 1. poddel: Sprejemniki in bralniki
Advanced Surface Movement Guidance and Control System (A-SMGCS) - Part 5:

Harmonised Standard for access to radio spectrum for Multilateration (MLAT) equipment

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.

The present document may be made available in electronic versions and/or in print. The content of any electronic and/or

print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any

existing or perceived difference in contents between such versions and/or in print, the prevailing version of an ETSI

deliverable is the one made publicly available in PDF format at www.etsi.org/deliver.

Users of the present document should be aware that the document may be subject to revision or change of status.

Information on the current status of this and other ETSI documents is available at

If you find errors in the present document, please send your comment to one of the following services:

No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying

The content of the PDF version shall not be modified without the written authorization of ETSI.

DECT™, PLUGTESTS™, UMTS™ and the ETSI logo are trademarks of ETSI registered for the benefit of its Members.

3GPP™ and LTE™ are trademarks of ETSI registered for the benefit of its Members and

oneM2M™ logo is a trademark of ETSI registered for the benefit of its Members and

Intellectual Property Rights ................................................................................................................................ 6

Foreword ............................................................................................................................................................. 6

Modal verbs terminology .................................................................................................................................... 7

Introduction ........................................................................................................................................................ 7

1 Scope ........................................................................................................................................................ 8

2 References ................................................................................................................................................ 8

2.1 Normative references ......................................................................................................................................... 8

2.1 Informative references ........................................................................................................................................ 8

3 Definition of terms, symbols and abbreviations ....................................................................................... 9

3.1 Terms .................................................................................................................................................................. 9

3.2 Symbols ............................................................................................................................................................ 10

3.3 Abbreviations ................................................................................................................................................... 10

4 Technical requirements specifications ................................................................................................... 10

4.1 Environmental profile ....................................................................................................................................... 10

4.2 Conformance Requirements ............................................................................................................................. 11

4.2.1 Applicability ............................................................................................................................................... 11

4.2.1.1 Equipment with multiple functions ............................................................................................................. 11

4.2.2 Transmitter operating frequency and frequency error ................................................................................ 11

4.2.2.1 Definition .............................................................................................................................................. 11

4.2.2.2 Limits .................................................................................................................................................... 11

4.2.2.3 Conformance ......................................................................................................................................... 11

4.2.3 Spectrum mask ............................................................................................................................................ 11

4.2.3.1 Definition .............................................................................................................................................. 11

4.2.3.2 Limits .................................................................................................................................................... 11

4.2.3.3 Conformance ......................................................................................................................................... 12

4.2.4 Residual Power Output ............................................................................................................................... 12

4.2.4.1 Definition .............................................................................................................................................. 12

4.2.4.2 Limits .................................................................................................................................................... 12

4.2.4.3 Conformance ......................................................................................................................................... 12

4.2.5 Spurious emissions of transmitter in active mode ....................................................................................... 12

4.2.5.1 Definition .............................................................................................................................................. 12

4.2.5.2 Limits .................................................................................................................................................... 13

4.2.5.3 Conformance ......................................................................................................................................... 13

4.2.6 Sensitivity variation over the operating frequency range............................................................................ 13

4.2.6.1 Definition .............................................................................................................................................. 13

4.2.6.2 Limits .................................................................................................................................................... 13

4.2.6.3 Conformance ......................................................................................................................................... 13

4.2.7 RF selectivity and spurious response rejection ........................................................................................... 13

4.2.7.1 Definition .............................................................................................................................................. 13

4.2.7.2 Limits .................................................................................................................................................... 13

4.2.7.3 Conformance ......................................................................................................................................... 14

4.2.8 Inter-modulation response rejection ........................................................................................................... 14

4.2.8.1 Definition .............................................................................................................................................. 14

4.2.8.2 Limits .................................................................................................................................................... 14

4.2.8.3 Conformance ......................................................................................................................................... 14

4.2.9 Co-channel rejection ................................................................................................................................... 14

4.2.9.1 Definition .............................................................................................................................................. 14

4.2.9.2 Limits .................................................................................................................................................... 14

4.2.9.3 Conformance ......................................................................................................................................... 14

4.2.10 Blocking ...................................................................................................................................................... 14

4.2.10.1 Definition .............................................................................................................................................. 14

4.2.10.2 Limits .................................................................................................................................................... 14

4.2.10.3 Conformance ......................................................................................................................................... 15

4.2.11 Sensitivity ................................................................................................................................................... 15

4.2.11.1 Definition .............................................................................................................................................. 15

4.2.11.2 Limits .................................................................................................................................................... 15

4.2.11.3 Conformance ......................................................................................................................................... 15

4.2.12 Receiver spurious emissions ....................................................................................................................... 15

4.2.12.1 Definition .............................................................................................................................................. 15

4.2.12.2 Limits .................................................................................................................................................... 15

4.2.12.3 Conformance ......................................................................................................................................... 15

5 Testing for compliance with technical requirements .............................................................................. 16

5.1 Environmental conditions for testing ............................................................................................................... 16

5.1.1 General requirements .................................................................................................................................. 16

5.1.2 Procedure for Tests ..................................................................................................................................... 16

5.1.2.1 All Equipment ....................................................................................................................................... 16

5.1.2.2 Equipment including Transmitters ........................................................................................................ 16

5.2 Interpretation of the measurement results ........................................................................................................ 16

5.3 Test and General Conditions ............................................................................................................................ 16

5.3.1 Transmitter test signals ............................................................................................................................... 16

5.3.1.1 General Considerations ......................................................................................................................... 16

5.3.1.2 Test signal 1 .......................................................................................................................................... 17

5.3.1.3 Test signal 2 .......................................................................................................................................... 17

5.3.2 Simulated received signals .......................................................................................................................... 17

5.3.2.1 General Considerations ......................................................................................................................... 17

5.3.2.2 Test signal 3 .......................................................................................................................................... 18

5.3.2.3 Test signal 4 .......................................................................................................................................... 18

5.4 Transmitter tests ............................................................................................................................................... 18

5.4.1 Operating frequency and frequency error ................................................................................................... 18

5.4.1.1 Description ............................................................................................................................................ 18

5.4.1.2 Test conditions ...................................................................................................................................... 18

5.4.1.3 Method of measurement ........................................................................................................................ 18

5.4.1.4 Measurement procedure ........................................................................................................................ 19

5.4.2 Spectrum mask ............................................................................................................................................ 19

5.4.2.1 Description ............................................................................................................................................ 19

5.4.2.2 Test conditions ...................................................................................................................................... 19

5.4.2.3 Method of measurement ........................................................................................................................ 19

5.4.2.4 Measurement procedure ........................................................................................................................ 19

5.4.3 Residual power output ................................................................................................................................ 20

5.4.3.1 Description ............................................................................................................................................ 20

5.4.3.2 Test conditions ...................................................................................................................................... 20

5.4.3.3 Method of measurement ........................................................................................................................ 20

5.4.3.4 Measurement procedure ........................................................................................................................ 20

5.4.4 Spurious emissions of transmitter in active mode ....................................................................................... 21

5.4.4.1 Description ............................................................................................................................................ 21

5.4.4.2 Test conditions ...................................................................................................................................... 21

5.4.4.3 Method of measurement ........................................................................................................................ 21

5.4.4.4 Measurement Procedure ........................................................................................................................ 21

5.5 Receiver Tests .................................................................................................................................................. 22

5.5.1 Sensitivity variation over the operating frequency range............................................................................ 22

5.5.1.1 Description ............................................................................................................................................ 22

5.5.1.2 Test conditions ...................................................................................................................................... 22

5.5.1.3 Method of measurement ........................................................................................................................ 22

5.5.1.4 Measurement procedure ........................................................................................................................ 22

5.5.2 RF selectivity and spurious response rejection ........................................................................................... 23

5.5.2.1 Description ............................................................................................................................................ 23

5.5.2.2 Test conditions ...................................................................................................................................... 23

5.5.2.3 Method of measurement ........................................................................................................................ 23

5.5.2.4 Measurement procedure ........................................................................................................................ 23

5.5.3 Inter-modulation response rejection ........................................................................................................... 24

5.5.3.1 Description ............................................................................................................................................ 24

5.5.3.2 Test conditions ...................................................................................................................................... 24

5.5.3.3 Method of measurement ........................................................................................................................ 24

5.5.3.4 Measurement procedure ........................................................................................................................ 24

5.5.4 Co-channel rejection ................................................................................................................................... 25

5.5.4.1 Description ............................................................................................................................................ 25

5.5.4.2 Test conditions ...................................................................................................................................... 25

5.5.4.3 Method of measurement ........................................................................................................................ 25

5.5.4.4 Measurement procedure ........................................................................................................................ 25

5.5.5 Blocking ...................................................................................................................................................... 26

5.5.5.1 Description ............................................................................................................................................ 26

5.5.5.2 Test conditions ...................................................................................................................................... 26

5.5.5.3 Method of measurement ........................................................................................................................ 26

5.5.5.4 Measurement procedure ........................................................................................................................ 26

5.5.6 Receiver spurious emissions ....................................................................................................................... 27

5.5.6.1 Description ............................................................................................................................................ 27

5.5.6.2 Test conditions ...................................................................................................................................... 27

5.5.6.3 Method of measurement ........................................................................................................................ 27

5.5.6.4 Measurement Procedure ........................................................................................................................ 27

Annex A (informative): Relationship between the present document and the essential

requirements of Directive 2014/53/EU ......................................................... 29

Annex B (informative): Bibliography ................................................................................................... 31

Annex C (informative): Change history ............................................................................................... 32

History .............................................................................................................................................................. 33

IPRs essential or potentially essential to normative deliverables may have been declared to ETSI. The information

pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found

in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in

respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web

Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee

can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web

The present document may include trademarks and/or tradenames which are asserted and/or registered by their owners.

ETSI claims no ownership of these except for any which are indicated as being the property of ETSI, and conveys no

right to use or reproduce any trademark and/or tradename. Mention of those trademarks in the present document does

not constitute an endorsement by ETSI of products, services or organizations associated with those trademarks.

This draft Harmonised European Standard (EN) has been produced by ETSI Technical Committee Electromagnetic

compatibility and Radio spectrum Matters (ERM), and is now submitted for the combined Public Enquiry and Vote

The present document has been prepared under the Commission's standardisation request C (2015) 5376 final [i.3] to

provide one voluntary means of conforming to the essential requirements of Directive 2014/53/EU on the harmonisation

of the laws of the Member States relating to the making available on the market of radio equipment and repealing

Once the present document is cited in the Official Journal of the European Union under that Directive, compliance with

the normative clauses of the present document given in Table A.1 confers, within the limits of the scope of the present

document, a presumption of conformity with the corresponding essential requirements of that Directive, and associated

The present document is part 5, sub-part 1, of a multi-part deliverable covering Advanced Surface Movement Guidance

Part 1: "Community Specification for application under the Single European Sky Interoperability Regulation EC

Part 2: "Community Specification for application under the Single European Sky Interoperability Regulation EC

Part 3: "Community Specification for application under the Single European Sky Interoperability Regulation EC

Part 4: "Community Specification for application under the Single European Sky Interoperability Regulation EC

Part 5: "Harmonised Standard for access to radio spectrum for multilateration equipment":

Part 6: "Harmonised Standard for access to radio spectrum for deployed surface movement radar sensors";

Part 7: "Community Specification for application under the Single European Sky Interoperability Regulation EC

Part 8: "Community Specification for application under the Single European Sky Interoperability Regulation EC

Date of withdrawal of any conflicting National Standard (dow): 18 months after doa