ISO 10049:2019
(Main)Aluminium alloy castings — Visual method for assessing porosity
Aluminium alloy castings — Visual method for assessing porosity
This document specifies a visual method for assessing the porosity of the machined surface of aluminium alloy castings. The method does not apply to assessing porosity shown on radiograms.
Pièces moulées en alliages d'aluminium — Méthode visuelle d'évaluation de la porosité
General Information
Relations
Standards Content (Sample)
INTERNATIONAL ISO
STANDARD 10049
Second edition
2019-06
Aluminium alloy castings — Visual
method for assessing porosity
Pièces moulées en alliages d'aluminium — Méthode visuelle
d'évaluation de la porosité
Reference number
ISO 10049:2019(E)
©
ISO 2019
---------------------- Page: 1 ----------------------
ISO 10049:2019(E)
COPYRIGHT PROTECTED DOCUMENT
© ISO 2019
All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may
be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting
on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address
below or ISO’s member body in the country of the requester.
ISO copyright office
CP 401 • Ch. de Blandonnet 8
CH-1214 Vernier, Geneva
Phone: +41 22 749 01 11
Fax: +41 22 749 09 47
Email: copyright@iso.org
Website: www.iso.org
Published in Switzerland
ii © ISO 2019 – All rights reserved
---------------------- Page: 2 ----------------------
ISO 10049:2019(E)
Contents Page
Foreword .iv
1 Scope . 1
2 Normative references . 1
3 Terms and definitions . 1
4 Inspection requirements . 1
5 Method of inspection. 3
5.1 Surface conditions . 3
5.2 Inspection conditions . 3
5.3 Lighting conditions . 4
5.4 Qualification of the operators . 4
6 Acceptance conditions . 4
6.1 Image of discontinuities . 4
6.2 Severity levels . 4
7 Interpretation of results . 4
8 Order . 4
© ISO 2019 – All rights reserved iii
---------------------- Page: 3 ----------------------
ISO 10049:2019(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards
bodies (ISO member bodies). The work of preparing International Standards is normally carried out
through ISO technical committees. Each member body interested in a subject for which a technical
committee has been established has the right to be represented on that committee. International
organizations, governmental and non-governmental, in liaison with ISO, also take part in the work.
ISO collaborates closely with the International Electrotechnical Commission (IEC) on all
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.