This document defines the requirements for a two-components, high corrosion inhibiting epoxy primer.
The coating shall be suitable for use on suitably prepared metallic substrates, chromic acid anodised, or conversion coated aluminium alloys and other suitably prepared substrates.

    • sale 10% off
    • Standard
      18 pages
      English language
    • e-Library read for
      1 day

This document specifies the requirements for a two-components flexible polyurethane topcoat to be applied over EN 4687 and/or EN 4688 primers mainly for exterior aerospace applications.
The primer and the finish tested to this document will be from the same manufacturer applied in accordance with (i.a.w.) their instructions/Table 1.

    • sale 10% off
    • Standard
      20 pages
      English language
    • e-Library read for
      1 day

This document specifies methods of predicting the sound exposure level of shooting sound for a single
shot at a given reception point. Guidelines are given to calculate other acoustic indices from the sound
exposure level. The prediction is based on the angular source energy distribution of the muzzle blast as
defined in ISO 17201-1 or calculated using values from ISO 17201-2.
This document applies to weapons with calibres of less than 20 mm or explosive charges of less than
50 g TNT equiva...
view more

    • sale 10% off
    • Standard
      68 pages
      English language
    • e-Library read for
      1 day

This document specifies methods of predicting the sound exposure level of shooting sound for a single shot at a given reception point. Guidelines are given to calculate other acoustic indices from the sound exposure level. The prediction is based on the angular source energy distribution of the muzzle blast as defined in ISO 17201-1 or calculated using values from ISO 17201-2.
This document applies to weapons with calibres of less than 20 mm or explosive charges of less than 50 g TNT equivalent...
view more

    • sale 10% off
    • Standard
      68 pages
      English language
    • e-Library read for
      1 day

This document specifies a method to determine the acoustic source energy of the muzzle blast for
calibres of less than 20 mm or explosive charges of less than 50 g TNT equivalent. It is applicable at
distances where peak pressures less than 1 kPa (equivalent to a peak sound pressure level of 154 dB)
are observed. The source energy, directivity of the source and their spectral structure determined by
this procedure can be used as input data to sound propagation programmes, enabling the predic...
view more

    • sale 10% off
    • Standard
      47 pages
      English language
    • e-Library read for
      1 day

This document specifies methods of predicting the sound exposure level of shooting sound for a single shot at a given reception point. Guidelines are given to calculate other acoustic indices from the sound exposure level. The prediction is based on the angular source energy distribution of the muzzle blast as defined in ISO 17201-1 or calculated using values from ISO 17201-2. This document applies to weapons with calibres of less than 20 mm or explosive charges of less than 50 g TNT equivalent,...view more

    • sale 15% off
    • Standard
      59 pages
      English language
    • sale 15% off
    • Standard
      63 pages
      French language

This document specifies a method to determine the acoustic source energy of the muzzle blast for calibres of less than 20 mm or explosive charges of less than 50 g TNT equivalent. It is applicable at distances where peak pressures less than 1 kPa (equivalent to a peak sound pressure level of 154 dB) are observed. The source energy, directivity of the source and their spectral structure determined by this procedure can be used as input data to sound propagation programmes, enabling the prediction...view more

    • sale 10% off
    • Standard
      47 pages
      English language
    • e-Library read for
      1 day

This document specifies a method to determine the acoustic source energy of the muzzle blast for calibres of less than 20 mm or explosive charges of less than 50 g TNT equivalent. It is applicable at distances where peak pressures less than 1 kPa (equivalent to a peak sound pressure level of 154 dB) are observed. The source energy, directivity of the source and their spectral structure determined by this procedure can be used as input data to sound propagation programmes, enabling the prediction...view more

    • sale 15% off
    • Standard
      39 pages
      English language
    • sale 15% off
    • Standard
      42 pages
      French language

The requirements of EN 9100 apply with the following clarification for software.
This European standard supplements the EN 9100 standard requirements for deliverable software and
contains quality management system requirements for organizations that design, develop, and/or
produce deliverable software and services for the aviation, space, and defence industry. This includes,
as required, support software that is used in the development and maintenance of deliverable software
and services. T...
view more

    • sale 10% off
    • Standard
      27 pages
      English language
    • e-Library read for
      1 day

This document includes EN ISO 9001:20152 quality management system requirements and
specifies additional aviation, space and defence industry requirements, definitions and notes.
It is emphasized that the requirements specified in this document are complementary (not
alternative) to customer and applicable statutory and regulatory requirements.
If there is a conflict between the requirements of this document and customer or applicable
statutory or regulatory requirements, the latter shall t...
view more

    • sale 10% off
    • Standard
      59 pages
      English language
    • e-Library read for
      1 day

IEC 62792:2015 specifies a method for measuring the electrical outputs, current and voltage, from electroshock weapons (ESWs) that deliver an electrical stimulus to humans. Manufacturers, medical researchers, policy makers, users, and other interested parties involved with different aspects of ESWs use a variety of different measurement methods, different terminologies, and different parameters to measure and describe the performance of an ESW. These differences generate confusion and misunderst...view more

    • sale 15% off
    • Standard
      57 pages
      English and French language

EN 16701 describes a method for assessing the deflagration to detonation transition (DDT) risk of an explosive material subjected to a mechanical threat. Testing applies to any compact solid explosive material.

    • sale 10% off
    • Standard
      16 pages
      English language
    • e-Library read for
      1 day

This Standard applies to the provision, development, use, improvement and disposal of defence products and services in accordance with Chapter 2 of Directive 2009/81/EC. It also applies to measures intended to maintain the operational readiness of products. This Standard supports project managers in the selection and use of applicable standards and standard-like documents.

    • sale 10% off
    • Standard
      7 pages
      English language
    • e-Library read for
      1 day

This Standard applies to the provision, development, use, improvement and disposal of defence products and services in accordance with Chapter 2 of Directive 2009/81/EC. It also applies to measures intended to maintain the operational readiness of products. This Standard supports project managers in the selection and use of applicable standards and standard-like documents.

    • sale 10% off
    • Standard
      7 pages
      English language
    • e-Library read for
      1 day

This Technical Report is applicable to any non-exempt military equipment.
This Technical Report does not affect the requirements to meet military standards.
This Technical Report only covers aspects related to EMC as covered by the EMC Directive
2004/108/EC and other directives that address EMC. In this respect there is no distinction between
civilian and defence equipment.
For the purpose of this Technical Report the term “military” is equivalent to the term “defence”.
Annex B describes A...
view more

    • sale 10% off
    • Technical report
      44 pages
      English language
    • e-Library read for
      1 day

This part of ISO 17201 gives guidelines for noise management of shooting activity at shooting ranges. The control of the noise received outside shooting ranges at specified reception points based either on measured or calculated sound exposure levels is specified. This part of ISO 17201 can also be used in the planning of new or reconstruction of existing ranges. It is intended to comply with all relevant local rules and regulations which imply a conversion of sound exposure level to other indic...view more

    • sale 10% off
    • Standard
      33 pages
      English language
    • e-Library read for
      1 day

ISO 17201-5:2010 gives guidelines for noise management of shooting activity at shooting ranges. The control of the noise received outside shooting ranges at specified reception points based either on measured or calculated sound exposure levels is specified. ISO 17201-5:2010 can also be used in the planning of new or reconstruction of existing ranges. It is intended to comply with all relevant local rules and regulations which imply a conversion of sound exposure level to other indicators as giv...view more

    • sale 10% off
    • Standard
      33 pages
      English language
    • e-Library read for
      1 day

ISO 17201-5:2010 gives guidelines for noise management of shooting activity at shooting ranges. The control of the noise received outside shooting ranges at specified reception points based either on measured or calculated sound exposure levels is specified. ISO 17201-5:2010 can also be used in the planning of new or reconstruction of existing ranges. It is intended to comply with all relevant local rules and regulations which imply a conversion of sound exposure level to other indicators as giv...view more

    • sale 15% off
    • Standard
      25 pages
      English language
    • sale 15% off
    • Standard
      25 pages
      English language
    • sale 15% off
    • Standard
      27 pages
      French language
    • sale 15% off
    • Standard
      27 pages
      French language

This part of ISO 17201 specifies methods for estimating the acoustic source data of muzzle blast and explosions and the source data of projectile sound on the basis of non-acoustic data for firearms with calibres less than 20 mm and explosions less than 50 g TNT equivalent. This part of ISO 17201 addresses those cases where no source measurements exist or where the data necessary to calculate projectile sound according to ISO 1720 1-4 are unknown. An example of this situation would be measuring ...view more

    • sale 10% off
    • Standard
      38 pages
      English language
    • e-Library read for
      1 day

ISO 17201-2:2006 specifies methods for estimating the acoustic source data of muzzle blast and explosions and the source data of projectile sound on the basis of non-acoustic data for firearms with calibres less than 20 mm and explosions less than 50 g TNT equivalent.
It addresses those cases where no source measurements exist, or where the data necessary to calculate projectile sound according to ISO 17201-4 are unknown. An example of this situation would be measuring projectile sound from sho...
view more

    • sale 10% off
    • Standard
      38 pages
      English language
    • e-Library read for
      1 day

This part of ISO 17201 provides a computational model for determining the acoustical source level of projectile sound and its one-third-octave-band spectrum, expressed as the sound exposure level for nominal mid-band frequencies from 12,5 Hz to 10 kHz. It also gives guidance on how to use this source level to calculate the sound exposure level at a receiver position. This part of ISO 17201 is intended for calibres of less than 20 mm, but can also be applied for large calibres. Additionally, the ...view more

    • sale 10% off
    • Standard
      26 pages
      English language
    • e-Library read for
      1 day

ISO 17201-2:2006 specifies methods for estimating the acoustic source data of muzzle blast and explosions and the source data of projectile sound on the basis of non-acoustic data for firearms with calibres less than 20 mm and explosions less than 50 g TNT equivalent. It addresses those cases where no source measurements exist, or where the data necessary to calculate projectile sound according to ISO 17201-4 are unknown. An example of this situation would be measuring projectile sound from shot...view more

    • sale 15% off
    • Standard
      31 pages
      English language
    • sale 15% off
    • Standard
      31 pages
      French language

ISO 17201-4:2006 provides a computational model for determining the acoustical source level of projectile sound and its one-third-octave-band spectrum, expressed as the sound exposure level for nominal mid-band frequencies from 12,5 Hz to 10 kHz. It also gives guidance on how to use this source level to calculate the sound exposure level at a receiver position.
ISO 17201-4:2006 is intended for calibres of less than 20 mm, but can also be applied for large calibres. Additionally, the data can be...
view more

    • sale 10% off
    • Standard
      26 pages
      English language
    • e-Library read for
      1 day

ISO 17201-4:2006 provides a computational model for determining the acoustical source level of projectile sound and its one-third-octave-band spectrum, expressed as the sound exposure level for nominal mid-band frequencies from 12,5 Hz to 10 kHz. It also gives guidance on how to use this source level to calculate the sound exposure level at a receiver position. ISO 17201-4:2006 is intended for calibres of less than 20 mm, but can also be applied for large calibres. Additionally, the data can be ...view more

    • sale 15% off
    • Standard
      19 pages
      English language
    • sale 15% off
    • Standard
      19 pages
      French language

D124/093: Referred to CLC/TC 205

    • sale 10% off
    • Standardization document
      24 pages
      English language
    • e-Library read for
      1 day